Mitsubishi Lancer Owners Manual
To listen to the radioFor pleasant driving / LW/MW/FM digital tuning radio with CD player / To listen to the radio
1. Press the PWR switch (1) or the AM/FM button (2) to turn ON the radio.
Press the PWR switch again to turn OFF the radio.
2. Press the AM/FM button (2) to select the desired band.
3. Turn the TUNE switch (4), or press the SEEK button (5 or 6) or memory select
buttons (3) to tune into a radio broadcasting station.
To tune the radio
Automatic tuning
After pressing the SEEK button (5 or 6), a receivable station will be automatically selected and reception of the station will begin.
Manual tuning
The frequency changes every time the TUNE switch (4) is turned. Turn the switch to select the desired radio broadcasting station.
To enter frequencies into the memory
Manual setting
You can assign to the memory select buttons (3) a maximum of 18 stations in the FM band (6 FM1, 6 FM2 and 6 FM3 stations) and 6 stations each in the MW and LW band. (Stations already assigned to the memory select buttons are replaced by any newly assigned stations.)
Follow the steps described below.
1. Press the SEEK button (5 or 6), or turn the TUNE switch (4) to tune to the
frequency you wish to keep in the memory.
2. Press one of the memory select buttons (3) until it beeps.
The sound will be momentarily interrupted while the frequency is being entered into
the memory. The number of the button matching the entry in the memory as well as
the frequency is displayed.
3. The preset memory setting is retrieved by pressing the button and then releasing
it within 1 second.
Note
► Disconnecting the battery terminal erases all the radio frequencies stored in the memory.
Automatic setting
With the method, all manually set stations in the band currently selected for reception are replaced with stations in the same band that are automatically selected in order of signal strength.
The radio automatically selects 6 stations in the FM band (FM3 station only) and 6 stations each in the MW and LW band.
Follow the steps described below.
1. With the radio mode selected, hold down the AM/FM button (2) for 2 seconds or longer.
The 6 stations with the best signal strength will automatically be assigned to the memory select buttons (3), with the lowest-frequency station being assigned to the lowest-number button.
2. When you subsequently press a memory select button to select a channel number, the radio will begin receiving the station assigned to that number.
Note
► If you press the AM/FM button (2) for 2 seconds or longer while tuning in the FM1 or FM2 band, the radio will automatically switch to the FM3 band, where the automatic seeking/storing will be activated.
