Mitsubishi Lancer Owners Manual
Fuse replacementMaintenance / Fuses / Fuse replacement
1. Before replacing a fuse, always turn off the electrical circuit concerned
and place the ignition switch in the “LOCK” position.
2. Remove the fuse puller (A) from the inside of the fuse box in the engine compartment.
3. Referring to the fuse load capacity table, check the fuse pertaining to the problem.
B- Fuse is OK
C- Blown fuse
Note
► If any system does not function but the fuse corresponding to that system is normal, there may be a fault in the system elsewhere. We recommend you to have your vehicle checked.
4. Insert a new fuse of the same capacity by using the fuse puller and insert the fuse at the same place in the fuse block.
► If the newly inserted fuse blows again after a short time, we recommend
you to have the electrical system checked to find the cause and rectify it.
► Never use a fuse with a capacity larger than that specified or any substitute,
such as wire, foil, etc.; doing so will cause the circuit wiring to heat up and
could cause a fire.
