Mitsubishi Lancer Owners Manual
Bulb capacityMaintenance / Replacement of lamp bulbs / Bulb capacity
When replacing a bulb, use a new bulb with the same wattage and colour.
Outside
Except for vehicles equipped with high intensity discharge headlamps
1. Front turn-signal lamps: 21 W (WY21W)
2. Headlamps, high-beam: 60 W (HB3)
3. Headlamps, low beam: 51 W (HB4)
4. Front fog lamps1: 55 W (H11)
5. Position lamps: 5 W (W5W)
6. Side turn-signal lamps2: 5 W
Vehicles equipped with high intensity discharge headlamps
1. Front turn-signal lamps: 21 W (WY21W)
2. Bending lamps (Adaptive Front lighting System (AFS)): 55 W (H11)
3. Headlamps, high/low beam (Discharge bulb)2: 35 W
4. Front fog lamps1: 55 W (H11)
5. Position lamps: 5 W (W5W)
6. Side turn-signal lamps2: 5 W
1 If so equipped
2 Have the lamps bulbs replaced at a MITSUBISHI MOTORS Authorized Service Point.
► Check with a MITSUBISHI MOTORS Authorized Service Point when it is necessary to repair a high intensity discharge headlamp or to replace the bulb. The power circuit, bulb and electrodes generate high voltages that may cause a severe shock.
Note
► For the side turn-signal lamp, it is not possible to repair or replace just
the bulb.
Check with a MITSUBISHI MOTORS Authorized Service Point when the lamp needs to be
repaired or replaced.
7. High-mounted stop lamp
8. Rear fog lamp: 21 W (W21W)
9. Licence plate lamps: 5 W (W5W)
10. Reversing lamps: 16 W (W16W)
11. Stop and tail lamps: 21/5 W (W21/5W)
12. Rear turn-signal lamps: 21 W (WY21W)
Codes in parentheses indicate bulb types.
Note
► The high-mounted stop lamp uses LEDs rather than bulbs. For repair and replacement, we recommend you to consult a specialist.
Inside
1- Cargo room lamp: 8 W
2- Rear room lamp: 8 W
3- Front room & map lamps: 8 W
